Specifications

REV.-A
3.2.7.6 Disassembly of Carriage
[Step 1]
[Step 2]
[Step 3]
[Step 4]
[Step 5]
[Step 6]
[Step 7]
[Step 8]
Remove the housing. (Refer to section 3.2. 1.)
Remove the printer mechanism. (Refer to section 3.2.4.)
Remove the printhead. (Refer to section 3.2.2.)
Remove the CAP
ASSY.. (Refer to section 3.2.7.2.)
Remove the FRAME, FRONT. (Refer to section 3.2.7.4.)
Remove the HOLDER, CABLE, PRINT HEAD which fastens
FPC to the FRAME, FRONT, and
release one end of the
FPC.
Unscrew the 3 screws (C.B.S. screw (M3 X 8)) which fasten the MOUNTING PLATE ASSY.,
PULLEY DRIVEN to the FRAME, FRONT, and remove the timing belt from the MOUNTING
PLATE
ASSY., PULLEY DRIVEN and pulley of CR motor.
Remove the 3 FLANGE NUT (M4) which fasten the SHAFT, CR, GUIDE, MAIN and SHAFT,
CR, GUIDE, SUB to the FRAME, FRONT, and then remove the carriage together with the
SHAFT, CR, GUIDE, MAIN and SHAFT, CR, GUIDE, SUB.
Timing Belt
C.B. S Screws (M3 X B)
+
FLANG NUT (M4)
w ‘
p-
i /
Figure
\\
‘)= PLAIN WASHER
FPC
‘Wk:::\spR’NG
\
FRAMEFR
-?
\ SPACER, CR,
GUIDE, SUB
HOLDER, CABLE,
~c
LEVER, PARALLEL, ADJUST
PRINT HEAD
e
, .
,’
~<+ FLANGE NIJT (M4)
3-25. Disassembly of Carriage (1)
[Step 9] Remove the 2 screws
(C.C. screw (M2.5 X6)) which fasten the encoder to the carriage.
[Step 10] Remove the CABLE
ASSY., HEAD from the carriage.
[Step 1 1] Remove the timing belt from the carriage.
E
AD
Figure 3-26. Disassembly of Carriage (2)
3-25