Specifications

REV.-A
3.2.7.5 Carriage Motor (DC MOTOR, CR) Removal
[Step 1]
Remove the housing. (Refer to section 3.2.1.)
[Step 2]
[Step 3]
[Step 4]
[Step 5]
[Step 6]
[Step 7]
Remove the printer mechanism. (Refer to section 3.2.4.)
Remove the CAP
ASSY.. (Refer to section 3.2.7.2.)
Remove the FRAME, FRONT. (Refer to section 3.2.7.4.)
Unscrew the 3 screws
(C.B.S. screw (M3 X 8)) which fasten the MOUNTING PLATE ASSY.,
PULLEY, DRIVEN to the FRAME, FRONT, and remove the timing belt from the pulley.
Unscrew the 4 screws
(C.C. screw (M3 X 12) X 3 and C.B.S. screw (M3 X 8) X 1 ) which fasten
the carriage motor (DC MOTOR, CR) and the MOUNTING PLATE, MOTOR, CR, to the FRAME,
FRONT and remove the carriage motor together with the MOUNTING PLATE, MOTOR, CR.
Unscrew the 2 screws (CUP screw
(M3 X 5)) which fasten the carriage motor to the MOUNTING,
PLATE, MOTOR, CR and remove the carriage motor from the MOUNTING, PLATE, MOTOR,CR.
C.C. Screws (M3x8)
MOUNTING
Timiny Belt
PLATE ASSY.,
PULLEY,
DRIVEN
FRAME, FRONT
CARRIAGE MOTOR DAMPER
-- MOUNTING PLATE, MOTOR, CR
C7
, ,.
,.
CR.
Figure 3-24. Carriage Motor (DC MOTOR, CR) Removal
ASSEMBLY POINTS
. . . .
c ‘
When attaching the carriage motor to the MOUNTING PLATE, MOTOR CR be sure to set the motor
-
in the correct attitude. Note the direction of the cord shown in Figure 3-24.
REQUIRED ADJUSTMENT ITEMS
-
If you have replaced the carriage motor, make the following adjustment
● Timing belt tension adjustment (Refer to section 4.3.)
3-24