Specifications

REV.-A
3.2.7.4 FRAME, FRONT Removal
[Step 1] Remove the housing. (Refer to section 3.2. 1.)
[Step2] Remove the printer mechanism. (Refer to section 3.2.4)
[Step3] Remove the CAP
ASSY.. (Referto section 3.2.7.2.)
[Step4] Remove the TUBE, SUPPLY, INK from the hook on the PUMP ASSY..
[Step 5] Remove the harness of the platen gap sensor from the clamp in the rear of the printer
[Step 6]
[Step 7]
[Step 8]
[Step 9]
mechanism.
Unscrew
C.B.S. screw (M3 X 8) which fastens the resistor to the rear of the printer, and remove
the resistor.
Unscrew
C.B.S. screw (M3 X 8) which fastens the FRAME, STRENGTHEN, RIGHT to the FRAME,
FRONT.
Carefully peel off
FPC from the FRAME, FRONT. (FPC is adhered to the FRAME, FRONT with
adhesive double coated tape.)
Unscrew two screws (C. B.S. screw
(M3 X 8)) which fastens the FRAME, FRONT to the printer
mechanism, and remove the FRAME, FRONT.
CBS. Screws (M3 X 8)
C.B.S. Screw (M3 X 8)
F’RAME,
STRENGTHEN,
RIGHT
Figure 3-23. FRAME, FRONT Removal
3-23