User manual

92
5. Extrema cut-off limit: the tolerance for extrema inclusion. Choices are
0, 3, 5, 10, 15, 20, 30, 40, 50, 70 and 100%.
6. Profile start angle: The start of the circular analysis paths must not
coincide with the center of a beam line. The default is -26° since it is
very unlikely that a beam line will fall at that angle, but another starting
point could be selected.
7. Options: (See Figure B-2)
 Show analysis path control: Hides the sliders used to specify the
diameter of the analysis circles and the analysis profile path width.
Show sensitivity slider: Allows the number of regression points to
be adjusted with a slider - see the Section on this topic above.
 Show profile start angle: Displays/hides the starting angle.
 Show analysis path: Displays/hides the analysis paths.
 Show analysis points: Displays/hides the analysis points – i.e. the
detected centers of the beams.
Figure B-2