User manual

61
Right click anywhere in the chart to access another set of
selections for the chart display and control the values along x
and y axes, format the units, show a probability histogram or
cumulative histogram and change the number of data clusters
for the histogram display.
Note: Click the command line “Display mode” and activate one
of the choices to display a histogram table in addition to the
chart. And remember that throughout the FilmQA
™
Pro
application any table, chart or image can be transferred into
other Windows-based applications using point/click and
copy/paste commands.
Display options in the Film Evaluation Panel, or Analysis Window are available
along the left border. Eight tabs control the following type of analysis data:
The Statistics Tab displays statistics of any film or user-defined area of
interest displayed in the Image Panel and has been described in a previous
Section.
The Profile Tab activates the display of a user-defined profile in the Analysis
Window. The initial display is the default profile diagonally top-left to bottom-
right across the Selection Frame. Right click the Profile icon and select
the profile settings listed below:
1. Line: User sets the position, length and orientation of the profile line
2. Vertical line: User sets the position and length of a vertical line
3. Horizontal line: User sets the position and length of a horizontal line
4. Multiple lines: A freehand path of multiple lines can be defined
5. Full vertical line: User sets the position of a vertical line across the
entire image