User manual
128
11. Right click the areas of interest (Figure 6A) to name the region types as
“Calibration Region”. Then right click the regions, select “Calibration Value”
(Figure 6B), type in the dose, press “enter” and then “OK” (Figure 6C).
Figure 6A Figure 6B
Figure 6C
12. Right click on “Dose map single scan” and select “Dose mapping method”,
“Recalibration using reference regions” and “Dose linear scaling” (Figure 7A).
Again right click on “Dose map single scan” and select “Rebuild Dose Map”
(Figure 7B).