User manual

126
8. Expand the Dose Map selection. Right click “Data - dose film” choosing “Scan
Image ‘dose film’” from the drop down menu. The Epson
®
Driver Window will
appear. Choose the settings shown in Figure 3C. If the color correction icons are
active (red arrow in Figure 3A) they must be de-activated. Open the
Configuration window (Figure 3B) and check “No Color Correction”. The icons
should appear gray (green arrow below, right). Note: Resolution of 72 dpi is
suggested.
Figure 3A Figure 3B Figure 3C
9. Place the application film, the calibration film(s) and an unexposed calibration
film on the scanner as shown in Figure 4. The time between film exposure and
scanning is related to the time window within which the calibration strip and
application film were exposed. Your efficiency increases when you minimize the
time window. For exposures t min. apart, film scanning can be done 4t min. later,
or any time thereafter.
Incorrect! Color correction
must be turned off.
Open Configuration window
and check “No color
correction”
Correct! Color
correction is not active