QuickSpecs

QuickSpecs
HP EliteBook Folio 1040 G1 Notebook PC
Technical Specifications
c04111345 — Worldwide — Version 19 — October 29, 2014
Page 15
Data transfer mode
PCIe-based interface for active state operation (S0 state) and SMBus for
host and management traffic (Sx low power state)
Power requirement
Requires 3.3V and 0.9V or just 3.3V with integrated regulators
Power consumption 0.733 Watts
Boot ROM support
Yes
Network transfer mode
Full-duplex
Half-duplex (not supported for the 1000BASE-T transceiver)
Network transfer rate
10BASE-T (half-duplex) 10 Mbps
10BASE-T (full-duplex) 20 Mbps
100BASE-TX (half-duplex) 100 Mbps
100BASE-TX (full-duplex) 200 Mbps
1000BASE-T (full-duplex) 2000 Mbps
Environmental
Operating Temperature:
0° to 85° C
Operating Humidity:
60% RH
Management
WOL, auto MDI crossover, PXE, Muti-port teaming, RSS, Advanced cable
diagnostic.
Alerting
ASF 2.0 support; iAMT 9.0 support
Optional Near Field
Communications (NFC)*,
**
NFC Specifications
ISO/IEC 14443A, ISO/IEC 14443B PCD 106 kbps to 848 kbps
ISO/IEC 14443A, ISO/IEC 14443B PICC 106 kbps to 424 kbps
ISO/IEC 15693/ICODE reader
NFC-IP1 and NFC-IP2 protocols, 106 kbps to 424 kbps
MIFARE reader encryption mechanism
NFC Forum Types 1-4 card reader
Supported Host
Interfaces
I2C
Automatic wakeup from Standby via host control interface
Dimensions
0.18 x 0.18 x 0.04 in (4.5 x 4.5 x 0.9 mm)
Frequency Band
13.56 MHz ISO Band
RF Output Voltage
3.3 V max
150 mA max (@3.0V output)
Power Consumption
1.5 W (max)
Antenna
Built-in
Antenna Range
Up to 0.79 in (2 cm)
Secure Element
Interfaces
SWP/HCI according to ETSI/SCP standardization
ISO/IEC 28361 (ECMA 373) NFC-WI. Data rate restricted to 106kbps
Embedded Secure
Element (eSE)
P5CN145 SmartMX Secure Dual Interface PKI Smart Card Controller
eSE Memory
144 kB EEPROM
264 kB User ROM
7.5 kB RAM (5 kB standard, 2.5 kB FameXE RAM)
Operating Temperature
-13 to 185
o
F (-25 to +85
o
C)
* NFC ships enabled by default on Windows 8.1 and disabled by default on Windows 7.
** Sold separately or as an option.