User`s guide

F
Set today's date.
Use C/D to select, and then press A.
G
Set the Date Format.
Use C/D to select, and then press A.
H
Go to a location outside with no
obstructions overhead.
c
Important:
Take the following steps to receive a signal
from the GPS and synchronize time
automatically. Since the signal from the
GPS cannot be received indoors, go outside
to a location without any obstructions
overhead.
I
Complete the settings.
Use C/D to select Yes, and then press A.
A signal is received from the GPS and time is
automatically synchronized.
When Complete is displayed, press A.
The time screen is displayed.
Note:
❏ When you leave the device for a while, it enters sleep
status and the time display turns off. This is not a
malfunction as the display is restored the next time
you move the device.
❏ If time synchronization fails, the signal from the GPS
may not be being received properly. Perform Time
Adjust from Sys. Settings.
U “Sys. Settings” on page 93
SF-710/510/310 User's Guide
Preparing and Basic Operations
26