User's Manual

Epson SureColor T-Series User’s Guide
Copying and Scanning
80
To change the copy settings or enlargement
ratio, press the Menu button to display the Copy
settings menu. When the Multifunction Scanner
is connected to the T7270D/T5270D, you can
specify the paper on which to print (Roll 1, Roll
2, Roll Auto, or Cut Sheet) in the Copy Settings
menu.
Using the Copy Settings menu
U“Menu Operations” on page 131
Settings
U“Large Copy / Large Scan menu” on page
162
7
When copying has finished, the screen returns
to the one in Step 6. Press the r button to eject
the document. When the Z button is pressed
after loading a document, copying can continue.
After copying has finished, always eject the
document. If the next document is loaded with
the previous document still inside, the next
document cannot be fed correctly.
You can change the eject direction of the
document.
Changing the eject direction
U“How to change the document eject
direction and scanning accuracy” on page 78
Large Scan
You must do the settings in advance to do "Scan to
e-mail" or "Scan To Shared Folder".
U“Preparing to Scan” on page 75
This section describes the procedure to scan on the
control panel of the printer.
Buttons that are used in the following settings
1
Turn on the printer by pressing the P button.
If the printer is turned on, the scanner is also
turned on.
2
Load paper suitable for the large scan function
of the printer.
U“Epson Special Media Table” on page 199
3
Load document on the scanner.
U“When you load a document that is more
than 0.25mm thick” on page 76
4
Make sure that the Large copy/Large scan screen
appears.
If another screen appears, use the l/r buttons
to select the tab.
5
At Large copy/Large scan screen, use the d/u
buttons to select Scan and press the Z button.