User's Manual

Epson SureColor T-Series User’s Guide
Copying and Scanning
78
2
With the side of the document to be read facing
up, align the right edge of the document with the
loading guide.
3
Insert the document horizontally so that the
entire edge touches all inner rollers.
If the edge touches the roller, the document is
fed to the read start position automatically.
After automatic loading starts, release your
hand and do not obstruct the loading of the
document.
4
After the document has been loaded, remove the
loading guide, and then make sure the left edge
of the document and the guide line are aligned.
If the document is copied or scanned with the
loading guide still attached, the edge of the
document may be damaged.
How to change the document
eject direction and scanning
accuracy
The procedure to change the document eject direction
and to change to a higher scanning accuracy is
described below.
c
Important:
If the document slants greatly from the
guide line, the slanted and protruding
section is not copied or scanned. Press the
r button to eject the document, and then
reload the document.
Note:
If the document is 1 m or longer, support it with
your hands so that it does not slant during
reading.
Note:
If you change the document eject direction to
backward, attach the paper eject guides before use. If
the document is ejected backward while the paper eject
guides are not installed, the document may be damaged
if it falls to the back and gets dirty or creased.