User's Manual

Epson SureColor T-Series User’s Guide
Basic Operations
54
Using the Control Panel
This section describes how to use the control panel for
the auto take-up reel unit.
Attaching the Paper
This section describes how to attach roll paper to the
auto take-up reel unit roll core.
The procedure varies with the take-up direction.
Taking Up the Paper Printable Side
Out
For information on installing the roll core, see the
Setup Guide for the optional auto take-up reel unit.
c
Important:
Confirm that the end of the roll is cut straight
across. The unit will not function as expected if
the end of the roll is wavy or curved.
U“Manual cut method” on page 35
Note:
For information on installing the auto take-up reel unit,
see the documentation supplied with the auto take-up
reel unit attachment.
A Power lamp
Displays the status of the auto take-up reel unit.
On : The auto take-up reel unit is
ready for use.
Flickering : The auto take-up reel unit is in
use.
Blinking : The auto take-up reel unit is in
power-saving mode.
Intermittent
blinking
: An error has occurred.
Off : The power is off.
B Auto switch
Selects the auto take-up direction.
Backwar
d
: The roll is taken up with the printable
side in.
Forward : The roll is taken up with the printable
side out.
Off : The auto take-up reel unit does not take
up paper.
C Manual switch
Selects the manual take-up direction.
The setting selected with the Manual switch takes
effect when the Auto switch is in the Off position.
Backwar
d
: The roll is taken up with the printable
side in.
The speed will increase after the button
is pressed for more than three seconds.
Forward : The roll is taken up with the printable
side out.
The speed will increase after the button
is pressed for more than three seconds.
c
Important:
Before proceeding, select Off for Auto Cut. Using
the auto take-up reel unit when On is selected will
cause errors.
U“Cutting the roll paper” on page 34
B Auto switch