Operation Manual

B
When using the Auto Take-up Reel Unit, raise
the tension bar.
C
Raise the cutter, and then move it so that the
cutter blade fits the cutter grove properly.
If you cannot position your hand correctly due
to the front cover, open the front cover and
then cut.
c
Important:
When you cut the media, check that it does
not rise up inside the front cover or has not
come free from the media edge plate before
printing.
D
Set the Auto switch to Off. Take up the cut
media completely by operating the Manual
switch according to how the media is rolled.
Removing Media
Caution:
❏ If the media weighs over 20 kg, it should not
be carried by one person. When loading or
removing the media, use at least two people.
❏ Follow the instructions in the manual when
loading media or roll cores or removing the
take-up roll.
Dropping media, roll cores, or take-up rolls
could result in injury.
A
To prevent the media from sliding off the roll,
support the roll at its left end.
B
Loosen the left roll core holder fixing screw and
remove the roll core holder from the roll.
SC-S80600 Series/SC-S60600 Series/SC-S40600 Series User's Guide
Basic Operations
43