Specifications

142 EPSON S1C6P466 TECHNICAL MANUAL
APPENDIX A PROM PROGRAMMING
(11) Terminating the Control Software
Execute the QUIT command to terminate the control software.
63P466:Q
Note: Restarting the control software after it has been terminated without the QUIT command, for
instance the MS-DOS prompt window is closed, may cause an error such as "RAM CLEAR
ERROR". In this case, turn the Universal Writer off once and then turn on before starting up the
control software.
(12) Power off
Turn the Universal Writer off (POWER SW is located at the side panel) then the personal computer.