Specifications
Table Of Contents
- 1 Introduction
- 2 S5U1C63000H6 Package
- 3 Connection
- 4 Getting Started
- 5 Operations and Functions of the S5U1C63000H6
- 5.1 Outline of Operation
- 5.2 Break Function
- 5.3 Monitoring Terminals
- 5.4 Display During Execution and During Break
- 5.5 Break Commands
- 5.6 Target Interrupt and Break
- 5.7 Trace Function
- 5.8 Trace Mode
- 5.9 Trace Trigger Point
- 5.10 Coverage Function
- 5.11 Measurement of Execution Time
- 5.12 Self-Diagnostic Function
- 5.13 Restrictions on Emulation
- 6 LCD Driver
- 7 Notes on Use
- 8 Maintenance and Warranty
- 9 Troubleshooting
9 TROUBLESHOOTING
20
EPSON
S5U1C63000H6 MANUAL
(S1C63 Family In-Circuit Emulator)
9 Troubleshooting
Following shows some hardware errors and their possible causes.
(1) A message of “connecting USB ... failure” is displayed at start-up of the debugger.
• Is power of the S5U1C63000H6 on?
• Is the circuit breaker (CB) off?
• Is the host cable connected correctly?
• Is the target cable connected correctly?
• Is the peripheral circuit board insert firmly?
(2) The circuit breaker (CB) trips and the POWER LED goes out when the S5U1C63000H6 is
turned on.
• Is the target cable connected correctly?
• Is VDD and VSS short-circuited on the target board?
Refer to the “S5U1C63000A Manual” for operations of the debugger.