Specifications
Table Of Contents
- 1 Introduction
- 2 S5U1C63000H6 Package
- 3 Connection
- 4 Getting Started
- 5 Operations and Functions of the S5U1C63000H6
- 5.1 Outline of Operation
- 5.2 Break Function
- 5.3 Monitoring Terminals
- 5.4 Display During Execution and During Break
- 5.5 Break Commands
- 5.6 Target Interrupt and Break
- 5.7 Trace Function
- 5.8 Trace Mode
- 5.9 Trace Trigger Point
- 5.10 Coverage Function
- 5.11 Measurement of Execution Time
- 5.12 Self-Diagnostic Function
- 5.13 Restrictions on Emulation
- 6 LCD Driver
- 7 Notes on Use
- 8 Maintenance and Warranty
- 9 Troubleshooting
3 CONNECTION
S5U1C63000H6 MANUAL
EPSON
5
(S1C63 Family In-Circuit Emulator)
3 Connection
This chapter describes the connection between S5U1C63000H6 and a host computer and a Peripheral Circuit Board
(S5U1C63xxxP).
3.1 AC Cable
The S5U1C63000H6 package includes a dedicated AC cable (with 2-pin plug) and AC adapter. The AC cable is
connected into the AC inlet on the AC adapter.
Host computer S5U1C63000H6
AC line
Frame ground line
AC cable
AC inlet
AC adapter
dedicated for
S5U1C63000H6
POWER
CB
FG
DC 12V
DC 12V
FG
DC cable
* We recommend to connect between the FG terminal of the S5U1C63000H6 and a frame ground.
Figure 3.1.1 Connection of AC Line
3.2 DC Cable
Connect the DC output cable of the AC adapter to the DC12V connector located at the S5U1C63000H6 rear panel.
3.3 Connecting with Host Computer
Connect between the host computer and the S5U1C63000H6 using the USB cable included in this package.
Host computer
USB connector
USB
S5U1C63000H6
POWER
CB
FG
DC 12V
Figure 3.3.1 Connecting with Host Computer