Specifications

CHAPTER 3: CONNECTIONS

8 EPSON S5U1C62000H MANUAL

(S1C60/62 FAMILY IN-CIRCUIT EMULATOR)

3.3 Connecting Evaluation Board

Figure 3.3.1 shows the external view of the Evaluation Board interface cable.

4950

S5U1C62000H side Evaluation Board side

Fig. 3.3.1 External view of Evaluation Board interface cable

The Evaluation Board interface cables are connected to the F1 and F5 connectors of the S5U1C62000H

with its projections (to prevent wrong insertion) inside (cable side). Likewise, they are connected to the

Evaluation Board with its projections outside.

The F1 and F5 connectors are lined up vertically on the side panel of the S5U1C62000H. Connect the F1

cable to the upper connector and the F5 cable to the lower connector.

Figure 3.3.2 shows the cable connection diagram.

Fig. 3.3.2 Cable connection between S5U1C62000H and Evaluation Board

Note: The Evaluation Board has the VDD and VSS terminals used when operating by itself. Do

not connect to these terminals when connecting to the S5U1C62000H. Power for the

Evaluation Board is supplied from the S5U1C62000H through the F1 and F5 cables.

The interface cables and connection to the F1 and F5 connectors of the S5U1C62000H are the same as

the Evaluation Board described above.

The F1 and F5 connectors of the small-sized Evaluation Board are lined up the same as the

S5U1C62000H. Connect the F1 cable to the upper connector and the F5 cable to the lower connector.

Fig. 3.3.3 Cable connection between S5U1C62000H and small-sized Evaluation Board

Note: The small-sized Evaluation Board has the DC IN (5V DC input terminal), GND and 5 V

terminals used when operating by itself. Do not connect to these terminals when connect-

ing to the S5U1C62000H. Power for the small-sized Evaluation Board is supplied from the

S5U1C62000H through the F1 and F5 cables.

S5U1C62000H Small-sized

Evaluation

Board

F1 connector→

Red mark

F5 connector→

←F1 connector

←F5 connector

S5U1C62000H

←F1 connector

Red mark

←F5 connector

Evaluation

Board