Specifications

6 MASK DATA CHECKER MDC6003
30 EPSON S5U1C60N03D MANUAL
(DEVELOPMENT SOFTWARE TOOL FOR S1C60N03)
■ Error messages
Program data error
System error
1. HEX DATA ERROR : NOT COLON.
2. HEX DATA ERROR : DATA LENGTH. (NOT 00-20h)
3. HEX DATA ERROR : ADDRESS.
4. HEX DATA ERROR : RECORD TYPE. (NOT 00)
5. HEX DATA ERROR : DATA. (NOT 00-FFh)
There is no colon.
The data length of 1 line is not in the 00–20H range.
The address is beyond the valid range of the program ROM.
The record type of 1 line is not 00.
The data is not in the range between 00H and 0FFH.
Error Message
Explanation
There are too many data in 1 line.
The checksum is not correct.
The end mark is not : 00000001FF.
There is duplicate definition of data in the same address.
6. HEX DATA ERROR : TOO MANY DATA IN ONE LINE.
7. HEX DATA ERROR : CHECK SUM.
8. HEX DATA ERROR : END MARK.
9. HEX DATA ERROR : DUPLICATE.
Function option data error
1. OPTION DATA ERROR : START MARK.
2. OPTION DATA ERROR : OPTION NUMBER.
3. OPTION DATA ERROR : SELECT NUMBER.
4. OPTION DATA ERROR : END MARK.
The start mark is not "\OPTION". (during unpacking) *
The option number is not correct.
The option selection number is not correct.
The end mark is not "\\END" (packing) or "\END" (unpacking).*
Error Message Explanation
Segment option data error
File error
1. <File_name> FILE IS NOT FOUND.
2. PACK FILE NAME (File_name) ERROR.
3. PACKED FILE NAME (File_name) ERROR.
The file is not found or the file number set in CONFIG.SYS
is less than 10.
The packed input format for the file name is wrong.
The unpacked input format for the file name is wrong.
Error Message Explanation
1. DIRECTORY FULL.
2. DISK WRITE ERROR.
The directory is full.
Writing on the disk is failed.
Error Message Explanation
* \ sometimes appears as ¥, depending on the personal computer being used.
1. SEGMENT DATA ERROR : START MARK.
2. SEGMENT DATA ERROR : DATA.
3. SEGMENT DATA ERROR : SEGMENT NUMBER.
4. SEGMENT DATA ERROR : SPEC.
5. SEGMENT DATA ERROR : END MARK.
The start mark is not "\SEGMENT". (during unpacking) *
The segment data is not correct.
The SEG No. is not correct.
The output specification of the SEG terminal is not correct.
The end mark is not "\\END" (packing) or "\END" (unpacking).*
Error Message Explanation