Specifications

5 ICE CONTROL SOFTWARE ICS6003
24 EPSON S5U1C60N03D MANUAL
(DEVELOPMENT SOFTWARE TOOL FOR S1C60N03)
5 ICE CONTROL SOFTWARE ICS6003
5.1 ICS6003 Outline
The In-Circuit Emulator (S5U1C62000H) connects the target board produced by the user via the evaluation
board (S5U1C62N37E) and performs real time target system evaluation and debugging by passing through
the RS-232C from the host computer and controlling it. The operation on the host computer side and ICE
(S5U1C62000H) control is done through the ICE Control Software ICS6003.
The ICS6003 has a set of numerous and highly functional emulation commands which provide sophisti-
cated break function, on-the-fly data display, history display, etc., and so perform a higher level of
debugging.
5.2 ICS6003 Restrictions
Take the following precautions when using the ICS6003.
■ ROM Area
The ROM area is limited to a maximum address of 2FFH. Assigning data above the 2FFH address
causes an error.
■ RAM Area
The RAM area is limited to a maximum address of 0EFH. However, as the following addresses are in
the unused area, designation of this area with the ICE commands produces an error.
Unused area: 040H to 0DFH
Memory 0E0H to 0EFH is display memory; 0F0H to 0FFH is I/O memory.
(Refer to the "S1C60N03 Technical Manual" for details.)
■ Undefined Code
The instructions below are not specified for the S1C60N03 and so cannot be used.
SLP
PUSH XP POP XP LD XP,r LD r,XP
PUSH YP POP YP LD YP,r LD r,YP
■ OPTLD Command
In the ICS6003, OPTLD command cannot be used.
Fig. 5.1.1 Debugging system using ICE
☞ The functions of the ICE and commands are same as for the S1C62 Family. Refer to the "S1C62
Family Development Tool Reference Manual" for details.
RS-232C
Host computer
(IBM PC/AT)
Target board
ICE Evaluation Board
S5U1C62N37E
S5U1C62000H