Technical information

5. CONNECTION
18 EPSON S1C33 Family In-Circuit Debugger
S5U1C33001H1400 Manual (Rev. 0.20)
5. CONNECTION
5.1 Connecting the S5U1C33001H1400 and the host computer
5.1.1 Connecting the USB Cable
The connectors at each end of the USB cable are type A (for the host computer) and Mini
B type (for the S5U1C33001H). Turn on the S5U1C33001H power and connect the USB
cable to the host computer. The host computer will request that the USB driver be installed.
Use the procedure described in the next section to install the USB driver.
Note: The USB driver is located in the directory in which the S5U1C33001C (S1C33
Family C Compiler Package) is installed:
C:\EPSON\gnu33\utility\drv_usb\Icd33v60.
Fig. 7 Connecting the USB cable
5.1.2 USB Driver Installation Procedure
(1) When th
e USB cable is first connected to the host computer, the hardware wizard will
be displayed.
(2) Install the USB driver by following the directions displayed by the wizard.
Specify “C:\EPSON\gnu33\utility\drv_usb\Icd33v60” as the USB driver directory.
The device manager will be displayed as shown below when the USB driver has been
installed correctly.
Note: When using the S5U1C33001H1400 (ICD33V6.0), use the following C compiler
package: GNU33V3.1.1 (Product No. not assigned), GNU33V3.2.0
(S5U1C33001C1300) or a later C Compiler Package.