Technical information

4. NAME AND FUNCTION OF EACH PART
12 EPSON S1C33 Family In-Circuit Debugger
S5U1C33001H1400 Manual (Rev. 0.20)
4.2 Right-side panel
Fig. 5 Right-side panel
4.2.1 DIP switch
Note: After opera
ting the DIP switches, press the RESET/START switch to apply the
settings.
• Selecting target CPU core (SW1)
Table 3-1 DIP SW1 setting
SW1 Setting
OPEN C33
ON C17 (Not supported)
• Selecting ICD mode/flash programmer mode (SW2, SW3)
Table 3-2 DIP SW2 and SW3 settings
SW2 SW3 Setting
OPEN OPEN ICD mode
ON OPEN Flash programmer mode Erase → Write
OPEN ON Flash programmer mode Verify
ON ON Flash mode Erase → Write → Verify
ICD mode: Mode for executing the debug command from the debugger in a PC (see the relevant section)
Flash programmer mode: Mode for operating the S5U1C33001H independently as a flash programmer (see relevant section)