Specifications
86
QR Code
Setting Description
Model Specifies a QR Code model (Model 11 or Model 12).
Module Width
Configures the cell (module) of QR Code to be printed. The
setting can be changed within the range of 1 to 16.
Version
Specifies the QR Code version.
Depending on the QR Code version, the number of
characters to be used for the 2D-Code changes.
The settable versions are 1 to 16 when the "Model 1" is
selected in the [Model], and 1 to 40 when the "Model 2" is
selected.
Error Correction Level
Specifies the error correction level for QR Code (Level L,
Level M, Level Q, Level H).
Rotation
Specifies the print direction of 2D-Code. When other than
"Normal" is selected in the Rotation setting, the following
message is displayed: "<Print all text as graphics image> will
be automatically set to yes."
When other than "Normal" is specified for the Rotation setting
both in the [Layout] tab and the [2D-Code] - [Advanced
settings], the both settings are applied to the printed 2D-
Code at a time.
Normal Prints the 2D-Code without rotating it.
Rotate by 90 Degrees
Rotates the 2D-Code to print it. The whole print data is
printed as a graphics image, therefore, the Device fonts,
control font, and controlA font cannot be used.
Rotate by 180 Degrees
Rotate by 270 Degrees
Hex Input Mode
Allows the 2D-Code characters to be entered in binary.
Ex : "00010203" J 0x00 0x01 0x02 0x03