Specifications

Chapter 3 Reference
49
3
Start printing
immediately
Specifies that the print device should begin printing after the first page
of the document is spooled. This makes the printing program available
sooner.
Configurable when [Spool print documents so program finishes printing
faster] is set.
Print directly to the
printer
Specifies that the document should be sent directly to the print device
and not spooled. Use this if you cannot print using either of the print
spooling options.
Hold mismatched
documents
Directs the spooler to check the printer setup and match it to the
document setup before sending the document to the print device. If
the information does not match, the document is held in the queue.
A mismatched document in the queue will not prevent correctly
matched documents from printing.
Configurable when [Spool print documents so program finishes printing
faster] is set.
Print spooled documents
first
Specifies that the spooler should favor documents that have completed
spooling when deciding which document to print next, even if the
completed documents are a lower priority than documents that are still
spooling. If there are no documents that have completed spooling, the
spooler will favor larger spooling documents over smaller ones. Use this
option if you want to maximize printer efficiency.
When this option is disabled, the spooler picks documents based only on
priority.
Configurable when [Spool print documents so program finishes printing
faster] is set.
Keep printed documents
Specifies that the spooler should not delete documents after they are
printed. This allows a document to be resubmitted to the printer from the
printer queue instead of from the program.
Configurable when [Spool print documents so program finishes printing
faster] is set.
Enable advanced
printing features
Specifies whether the advanced printing feature is enabled. When
enabled, metafile spooling is turned on and options such as Page Order,
Booklet Printing, and Pages Per Sheet are available, depending on your
printer. For normal printing, leave the advanced printing feature set to
the default (Enabled). If compatibility problems occur, you can disable
the feature. When disabled, metafile spooling is turned off and the
printing options might be unavailable.
Configurable when [Spool print documents so program finishes printing
faster] is set.
Printing Defaults... Click to configure the Printing Preferences.
Print Processor...
Click to specify the data type. In general, you do not need to change
either the default print processor or data type. However, a few programs
might require a specialized print processor and a particular data type to
print.
Separator Page... Not available.
Setting Description