Service manual

EPSON Stylus Photo R340/350 Revision A
Disassembly and Assembly Disassembly 96
2.3.25 Removing the PF Roller Assy.
 Illustration
Figure 2-97. Removing the PF Roller Assy.
 Parts/Components must be removed to remove the PF Roller Assy.
Paper Support Assy., Left Housing, Right Housing,
Panel Board Assy. (Panel Board and LCD Module), Upper Housing,
Rear Housing, Main Board Assy., ASF Assy., Shaft Assy. Holder,
Printer Mechanism, APG Assy., Print Head, Carriage Unit, CD-R Guide Assy.,
Front Paper Guide, Upper Paper Guide
 Disassembly Procedure
1. Remove the PF Grounding Spring from the notch ( ) of the Main Frame
with tweezers and then remove the spring from the PF Roller Assy.
2. Pull out the C ring from the PF Roller Assy. leftward, and move the Left PF
Roller Bushing inward.
3. Remove the flat washer from the right edge of the PF Roller Assy. and move
the Right PF Roller Bushing inward.
4. Lift the PF Roller Assy. along with the notch of the Main Frame, then release
the assy. from the two tabs ( ) of the Rear Paper Guide, and remove the assy.
PF Roller Assy.
Rear Paper Guide
PF Grounding
Spring
NotchC Ring
Left PF Roller Bushing
Hooked tab
Flat Washer
Right PF Roller Bushing
Hooked tab
C A U T I O N
When performing the next step, be careful not to touch or damage
the coated part of the PF Roller Assy.