Service manual

EPSON Stylus Photo R340/350 Revision A
Disassembly and Assembly Disassembly 91
2.3.23 Removing the Front Paper Guide and EJ Roller
Assy.
 Illustration (1)
Figure 2-91. Removing the Front Paper Guide and EJ Roller Assy. (1)
 Parts/Components must be removed to remove the Front Paper Guide and
EJ Roller Assy.
Paper Support Assy., Left Housing, Right Housing,
Panel Board Assy. (Panel Board and LCD Module), Upper Housing,
Rear Housing, Main Board Assy., ASF Assy., Shaft Assy. Holder,
Printer Mechanism, APG Assy., Print Head, Carriage Unit, CD-R Guide Assy.
 Disassembly Procedure
1. Release the tab ( ) of the Right EJ Link from the groove of the Right EJ
Frame Shaft Guide, and remove the Right EJ Link.
2. Remove the flat washer that secures the right side of the EJ Frame Assy.
3. Release the PF Timing Belt from the Spur Gear 37.242 and the Spur Gear
41.38.
4. Remove the flat washer that secures the Spur Gear 41.38 and pull out the Spur
Gear 41.38.
5. Remove the EJ Frame Assy. in the order and orientation shown in Figure
2-91.
6. Remove the flat washer that secures the Left EJ Link and slide the Left EJ
Link rightward.
Compression
Spring 1.27
Idle Roller Holder
Spur Gear
41.38
Spur Gear
37.242
Flat
Washer
PF Timing
Belt
Left Side of
the Printer
Hooked Tab
Right EJ Link
Right EJ Frame Shaft Guide
Flat Washer
Right Side of
the Printer
EJ Frame Assy.
12
Left EJ Link
Flat Washer
Left Side of the Printer
C A U T I O N
When performing the next step, be careful not to lose the
Compression Spring 1.27 as it comes off when the tension of the Idle
Roller Holder is reduced.
C A U T I O N
When performing the next step, be careful not to damage or deform
the Star Wheels incorporated in the EJ Frame Assy.