Service manual

EPSON Stylus Photo R340/350 Revision A

Disassembly and Assembly Disassembly 90

 Reinstalling the Slider Lock Lever

z Make sure that the Slider Lock Lever moves correctly

together with the Cap Slider.

 Reinstalling the Ink System

z Make sure that the Ink Tube is connected at the position

shown in the figure below. Improper connection of the tube

may cause ink leakage.

Figure 2-88. Ink Tube Connection Position

z Check the green line printed on the Ink Tube to make sure

that the tube is not twisted.

z Make sure that the Cap Assy. moves smoothly.

z Make sure that the all gears are correctly set to the shaft of

the Pump Frame and move smoothly.

z Make sure the Pump Assy. is correctly secured.

z Make sure the Ink Tube is free of flattening or compression.

z Face the green line on the Ink Tube in the direction of the

arrow, and attach the tube to the two retainers ( ) on the

bottom of the Cap Frame in the order shown below.

Figure 2-89. Reinstalling the Ink Tube

 Reinstalling the Main Frame Support Plate

z Set the four positioning holes ( ) of the Main Frame

Support Plate onto the guide pins.

z Tighten the screws in the order shown below.

Figure 2-90. Reinstalling the Main Frame Support Plate

The Green Line should

Face This Way

Positioning Holes

and Guide Pins

C.B.S 3x6

(7-9kgf.cm)