Service manual

EPSON Stylus Photo R340/350 Revision A

Disassembly and Assembly Disassembly 85

 Illustration (2)

Figure 2-80. Removing the CD-R Guide Assy. (2)

7. Remove the two screws ( ) that secure the Lower CD-R Guide.

8. Slide the Lower CD-R Guide to release it from the seven tabs ( ) and

remove it.

9. Remove the Compression Spring 5.1 and the Stacker Lock from the Upper

CD-R Guide.

10. Release the connector cable of the Tray/CD-R Sensor from the groove of the

Upper CD-R Guide, and remove the Tray/CD-R Sensor.

C.B.P 3x6 (5-7kgf.cm)

Hooked Tabs

Lower CD-R Guide

Hooked Tabs

Tray/CD-R Sensor

Groove

Hooked Tabs

Stacker Lock

Compression

Spring 5.1

C A U T I O N

When performing the following steps, be careful not to lose the

parts listed below.

 Tray Sensor Lever

 CD-R Sensor Lever

 Torsion Spring 2.8

 Torsion Spring 4.26

 Reinstalling the Tray/CD-R Sensor

z Set the two positioning holes of the Tray/CD-R Sensor onto

the two guide pins.

Figure 2-81. Reinstalling the Tray/CD-R Sensor

z Route the connector cable of the Tray/CD-R Sensor as

shown in Figure 2-80.

Positioning Holes and Guide Pins