Service manual

EPSON Stylus Photo R340/350 Revision A

Disassembly and Assembly Disassembly 84

2.3.21 Removing the CD-R Guide Assy.

 Illustration (1)

Figure 2-79. Removing the CD-R Guide Assy. (1)

 Parts/Components must be removed to remove the CD-R Guide Assy.

Paper Support Assy., Left Housing, Right Housing,

Panel Board Assy. (Panel Board and LCD Module), Upper Housing,

Rear Housing, Main Board Assy., ASF Assy., Shaft Assy. Holder,

Printer Mechanism, APG Assy., Print Head, Carriage Unit

 Disassembly Procedure

1. Remove the acetate tape and release the connector cable of the Tray/CD-R

Sensor.

2. Remove the Right EJ Grounding Spring from the Main Frame and the EJ

Roller Assy.

3. Remove the two screws ( ) that secure the Main Frame Support Plate, and

remove it.

4. Remove the three screws ( ) that secure the CD-R Guide Assy.

5. Remove the flat washers that secure the Left and Right CD-R Links (two

washers for each) with tweezers, then remove the Left/Right CD-R Links

from the CD-R Guide Assy.

6. Release the seven ribs ( ) that secure the CD-R Guide Assy. and remove it

first from its right side.

C.B.S 3x6 (6-8kgf.cm)

Left CD-R Link

CD-R Guide Assy.

Flat Washers

Ribs

C.B.S 3x6 (6-8kgf.cm)

Right CD-R Link

Flat Washer

Ribs

Flat Washer

Main Frame

Support Plate

Acetate Tape

C.B.S 3x6

(7-9kgf.cm)

Right Front Side

of the Printer

Right EJ Grounding Spring