Service manual

EPSON Stylus Photo R340/350 Revision A
Disassembly and Assembly Disassembly 75
2.3.17 Removing the Waste Ink Pads
 Illustration
Figure 2-63. Removing the Waste Ink Pads
 Parts/Components must be removed to remove the Waste Ink Pads.
Paper Support Assy., Left Housing, Right Housing,
Panel Board Assy. (Panel Board and LCD Module), Upper Housing,
Rear Housing, Main Board Assy., ASF Assy., Shaft Assy. Holder,
Printer Mechanism, Power Supply Assy.
 Disassembly Procedure
1. Remove the six Waste Ink Pads from the Lower Housing.
Lower Large Cap Ink Pad
(on the Lower Side)
Lower Small Cap Ink Pad
(on the Upper Side)
Small Waste Ink Pads
(on both the upper and
lower sides)
Upper Waste Ink Pad
Lower Waste Ink Pad
Reattach the six Waste Ink Pads so that their holes are properly set
onto the ribs ( ), guide pins ( ) and tabs ( ) on the Lower
Housing.
Figure 2-64. Reinstalling the Waste Ink Pads
A D J U S T M E N T
R E Q U I R E D
Whenever the Waste Ink Pads are replaced, be sure to perform the
required adjustment shown below. (See Chapter 3 for details on the
adjustments)
 Protection counter
Bottom Side
Top Side
Bottom Side
Top Side