Service manual

EPSON Stylus Photo R340/350 Revision A
Disassembly and Assembly Disassembly 73
 After making sure that the Waste Ink Tube is routed under the
Lower Waste In Pad, attach the Upper Ink Eject Porous Pad
Support to/in the position/orientation as shown in the figure
below making it contact with the Waste Ink Tube.
Figure 2-60. Reattaching the Upper Ink Eject Porous Pad Support
 Tie the following connector cables with a cable tie.
z CR Motor (route the cable as shown in Figure 2-50.)
z PF Motor
z PG Motor
z Tray/CD-R Sensor
z Power Supply Board
 After tying the cables, cut the cable tie leaving a 20 mm-length
margin.
 Tighten the screws to secure the Printer Mechanism and the
CD-R Paper Guide in the order shown in Figure 2-55.
 Make sure that the Waste Ink Tube is free of flattening or
compression.
 Make sure that the Cap Assy. moves smoothly.
OK NG
Upside
Downside
Upper Ink Eject Porous Pad Support
Lower Waste Ink Pad
Align the Edge of
the Pad with here
Right Rear Side of the Printer