Service manual

EPSON Stylus Photo R340/350 Revision A

Disassembly and Assembly Disassembly 63

 Illustration (2)

Figure 2-43. Removing the Shaft Assy. Holder (2)

 Removing the LD Roller Shaft

6. Release the two tabs ( ) that secure the Paper Block and remove it.

7. Release the two tabs ( ) that secure the LD Roller Shaft and remove it

together with the Clutch.

8. Remove the Spur Gear 36.8 from the LD Roller Shaft.

9. Release the Extension Spring 0.143 from the tabs ( ) of the Clutch and the

LD Roller Shaft and remove the spring together with the Clutch.

10. Remove the LD Roller from the LD Roller Shaft.

 Removing the PE Sensor

11. Remove the shaft of the PE Sensor Lever from the LD Roller Shaft Holder in

the order shown in Figure 2-43, and remove the PE Sensor Lever and the

Torsion Spring 0.22.

12. Remove the acetate tape that secures the PE Sensor connector cable, and

release the cable from the three tabs ( ) of the LD Roller Shaft Holder.

13. Release the PE Sensor from the tab ( ) and remove the sensor.

Paper Block

Guide Pins

LD Roller Shaft Holder

Positioning Holes

Guide Pins

LD Roller ShaftLD Roller

Spur Gear 36.8

Clutch

Extension Spring 0.143

Hooked

Tabs

PE Lever Sensor

Shaft

Torsion Spring 0.22

Straight Leg

L-shaped Leg

Shaft

Acetate Tape

Hooked Tabs

PE Sensor

Connector Cable

C A U T I O N

When performing the next step, do not touch the LD Roller with

bare hands.