Service manual

EPSON Stylus Photo R340/350 Revision A

Disassembly and Assembly Disassembly 62

2.3.11 Removing the Shaft Assy. Holder

 Illustration

Figure 2-42. Removing the Shaft Assy. Holder (1)

 Parts/Components must be removed to remove the Shaft Assy. Holder.

Paper Support Assy., Left Housing, Right Housing,

Panel Board Assy. (Panel Board and LCD Module), Upper Housing,

Rear Housing, Main Board Assy., ASF Assy.

 Disassembly Procedure

1. Move the Carriage Unit to the anti-home side.

2. Remove the two screws ( ) that secure the Shaft Assy. Holder.

3. Release the two tabs ( ) that secure the Shaft Assy. Holder upward with

tweezers and pull out the guide pin ( ) from the Ink System Frame.

4. Press down the left side of the Upper Paper Guide (when viewed from the rear

of the printer) to release the PE Sensor Lever from the notch, and then slide

the Shaft Assy. Holder rightward to remove the assy. toward you.

5. Release the Head Cable from the eight tabs ( ) of the Shaft Assy. Holder.

Carriage Unit

Anti-home Side

Head Cable

Hooked Tabs

Ribs

Shaft Assy. HolderHooked Tabs (x 4)

C.B.S 3x6

(6-8kgf.cm)

Hooked Tabs

Upper Paper

Guide

PE Lever Sensor

C A U T I O N

When performing the next step, be careful not to damage the PE

Sensor Lever as it comes into contact with the Upper Paper Guide.

C A U T I O N

When performing the next step, be careful not to damage the Head

Cable.