Service manual

EPSON Stylus Photo R340/350 Revision A
Disassembly and Assembly Disassembly 60
 Reassembling the ASF Assy.
z Hitch the L-shaped leg of the Torsion Spring 6.45 to the
shaft of the Paper Back Lever, and hitch the other shorter
leg of the spring to the groove of the ASF Assy.
Figure 2-34. Reattaching the Torsion Spring 6.45
z Make sure that the Paper Back Lever and the Retard Roller
Assy. move smoothly.
z Tighten the screws to secure the ASF Frame Support Plate
in the order shown in the figure below.
Figure 2-35. Reinstalling the ASF Frame Support Plate
Torsion Spring 6.45
L-shaped Leg
Shorter Leg
1
2
 Reinstalling the ASF Assy.
z Attach the Compression Spring 2.51 to the rib ( ) of the
Hopper and the two ribs ( ) of the ASF Frame, and make
sure that the Hopper moves smoothly.
Figure 2-36. Reinstalling the Hopper
z Set the guide pin ( ) of the ASF Assy. and the rib ( ) in
the positioning holes.
Figure 2-37. Reinstalling the ASF Assy. (1)
Ribs
Guide Pin
Rib
Right Side of the Printer