Service manual

EPSON Stylus Photo R340/350 Revision A

Disassembly and Assembly Disassembly 50

2.3.6 Removing the Rear Housing

 Illustration

Figure 2-15. Removing the Rear Housing

 Parts/Components must be removed to remove the Rear Housing.

Paper Support Assy., Left Housing, Right Housing,

Panel Board Assy. (Panel Board and LCD Module), Upper Housing

 Disassembly Procedure

1. Remove the screw ( ) that secures the Rear Cover and remove it.

2. Remove the two screws ( ) that secure the Rear Housing.

3. Slightly lift the Rear Housing to release it from the four tabs ( ), and remove

the Rear Housing.

Rear HousingRear Cover

C.B.S 3x8 (4-6kgf.cm)C.B.P 3x8 (4-6kgf.cm)

C.B.P 3x8 (4-6kgf.cm)

Hooked

Tabs

Hooked

Tabs

 Tighten the screws to secure the Rear Housing in the order

shown in Figure 2-15.

 Put the two tabs of the Rear Cover into the notches of the frame.

Figure 2-16. Reattaching the Rear Cover

Notches

Tabs