Service manual

EPSON Stylus Photo R340/350 Revision A
Disassembly and Assembly Disassembly 46
2.3.4 Removing the Panel Board/LCD Module
 Illustration (1)
Figure 2-8. Removing the Panel Board/LCD Module (1)
 Parts/Components must be removed to remove the Panel Board/LCD
Module.
None
 Disassembly Procedure
1. Open the Printer Cover and Stacker Assy.
2. Push the two hooked tab attaching positions on the Panel Board Assy. with a
flat-blade screwdriver to release the two tabs ( ) of the Cosmetic Panel and
then release the upper right tab ( ).
3. Release the lower four tabs ( ) that secure the Cosmetic Panel and remove it.
4. Release the two tabs ( ) located at both ends of the Panel Board Assy. with a
flat-blade screwdriver and then release the two tabs ( ) to remove the Panel
Board Assy.
5. Disconnect the Panel FFC and the LCD FFC from the connectors.
6. Remove the four screws ( ) that secure the Panel Shield Plate.
7. Release the Panel Shield Plate from the two grooves ( ) and remove the
panel pulling it out under the cable.
Cosmetic Panel
Hooked Tabs
Panel FFC
LCD FFC
Connectors
Panel Board Assy.
Hooked Tabs
Panel Shield Plate Grooves
C.B.P 3x8 (4-6kgf.cm)
1
Cable
4
3
2
Hooked
Tab of the
Cosmetic
Panel
Hooked Tab
Attaching
Position on
the Panel
Board Assy.
C A U T I O N
When performing the next step to remove the Cosmetic Panel, be
careful not to damage the two hooked tabs ( ) of the Cosmetic
Panel.
C A U T I O N
When performing the next step, be careful not to pull the Panel
Board Assy. too much as it is still connected to the printer with the
FFC and the FFC is secured with two-sided tape.