Service manual

EPSON Stylus Photo R340/350 Revision A
Disassembly and Assembly Disassembly 43
2.3.2 Removing the Left Housing
 Illustration
Figure 2-3. Removing the Left Housing
 Parts/Components must be removed to remove the Left Housing.
None
 Disassembly Procedure
1. Remove the screw ( ) that secures the Left Housing.
2. Open the Printer Cover.
3. Release the hooked tab of the Lower Housing from inside the housing, and
then push the Left Housing toward the rear of the printer to release the nine
tabs ( ), and remove the Left Housing.
Left Housing
Upper Housing
C.B.P 3x8 (6-8kgf.cm)
Hooked Tab
Attaching Position
Lower Housing
Left Side of
the Printer
Left Housing (inside)
Hooked Tabs
Make sure there is no gap between the Left Housing and the Upper
Housing.
Figure 2-4. Reinstalling the Left Housing
Should be no gap