Service manual

EPSON Stylus Photo R340/350 Revision A
Disassembly and Assembly Disassembly 41
2.3 Disassembly
The flowchart below lists the step-by-step disassembly procedures. When disassembling each unit, refer to the page number shown in the figure.
Figure 2-1. Removing Procedure Flowchart
NOTE 1: Parts or units indicated in do not mean that they can be omitted to disassemble. They also should
be disassembled for disassembling the following parts or units in the flowchart.
NOTE 2: To remove the part or component shown in a green box, the parts or components in yellow boxes located
just above the green box must be removed.
C H E C K
P O I N T
Since a prototype was used to illustrate these
disassembly and assembly procedures, the
appearance of some parts may differ from those
on an actual product. The procedures
themselves, however, are accurate for the retail
model.
Start
Removing the Shaft Assy.
Holder (p.62)
Removing the Printer
Mechanism (p.70)
Removing the Power Supply
Assy. (p.74)
Removing the Waste Ink Pads
(p.75)
Removing the Lower Housing
(p.76)
Removing the Stacker Assy.
(p.51)
Removing the Stacker Assy.
(p.51)
Removing the Print Head
(p.67)
Removing the CR Motor
(p.66)
Removing the Upper Paper
Guide (p.69)
Removing the Ink System
(p.88)
Removing the PF Motor (p.95)
Removing the CD-R Guide
Assy. (p.84)
Removing the Panel Board/
LCD Module (p.46)
Removing the Paper Support
Assy. (p.42)
Removing the Left Housing
(p.43)
Removing the Right Housing
(p.44)
Removing the Main Board
Assy. (p.54)
Removing the Rear Housing
(p.50)
Removing the APG Assy.
(p.77)
Removing the Print Head
(p.67)
Removing the Upper Housing
(p.48)
Removing the ASF Assy.
(p.58)
Removing the Carriage Unit
(p.78)
Removing the Front Paper
Guide and EJ Roller Assy. (p.91)
Removing the Upper Paper
Guide (p.69)
Removing the PF Roller Assy.
(p.96)
Removing the Front Paper
Guide Porous Pads (p.52)