Service manual

EPSON Stylus Photo R340/350 Revision A
Maintenance Overview 113
4.1.3 Lubrication
The lubrication used for the components of Stylus Photo R340/350 has been decided
on based on evaluation carried out by Epson. As a result, the specified amount of
lubricant should be applied in the places specified when carrying out repair and
maintenance work.
 When wiping off the grease during the cleaning
 If necessary when performing assembly/disassembly of the printer
 Refer to the following figures for the lubrication points.
C A U T I O N
 Never use oil or grease other than those specified in this
manual. Use of different types of oil or grease may damage the
components or affect the printer functions.
 Never apply a larger amount of oil or grease than specified in
this manual.
Table 4-1. Oil Applied to Stylus Photo R340/350
Type Name EPSON Code Supplier
Grease
G-26 1080614
EPSON
G-63 1218320
G-74 1409257
C A U T I O N
When using G-74, it is recommended to use a flux dispenser
(1049533) together.
<Lubrication Point>
Point on the right side of the
Hopper as shown in the figure
<Lubrication Type>
G-74
<Lubrication Amount>
Adequate dose
<Remarks>
• Use a flux dispenser to apply it
• Be careful not to apply too
much.
<Lubrication Point>
Two points on the Hopper shown
in the left figure.
<Lubrication Type>
G-74
<Lubrication Amount>
Adequate dose
<Remarks>
Use a flux dispenser to apply it
Lubrication Point
Hopper
Lubrication Point Lubrication Point
Hopper