Service manual

EPSON Stylus Photo R340/350 Revision A
Troubleshooting Warning/Error Messages and Possible Causes 10
External device is not connected or media
is not inserted. Backup canceled.
Backup error
(no external connection)
Occurs in the following conditions:
• An external device is not connected to the printer.
• No media is set into the connected external device.
• No image is stored on the memory card.
Automatically recovers from the error after a lapse
of three seconds.
---
Insufficient space on the backup device.
Backup cannot be performed.
Backup error
(insufficient capacity)
The capacity of the media specified to back up is
insufficient.
Automatically recovers from the error after a lapse
of three seconds.
---
No memory card in slot. Backup canceled. Backup error (no card) No memory card is inserted into the slot of the printer. Automatically recovers from the error after a lapse
of three seconds.
---
A printer error occurred. Please see your
manual.
Fatal error Occurs in the following conditions:
• The Carriage Unit cannot move properly because of
an external force exerted on the unit.
• The PF Motor cannot operate properly.
Turn off the Power. p.16
Paper out. Load paper press the Start
button.
No paper error The PE Sensor could not detect the top edge of paper
during the paper feeding sequence.
Press the Start button. The printer recovers from
the error when paper is fed correctly.
p.19
Paper or CD/DVD tray jam or feed error.
Press the Start button. If the error does not
clear, reinsert the paper or CD/DVD tray
and press the Start button.
Jam error Occurs in the following conditions:
• The PE Sensor could not detect the bottom edge of
paper during the paper feeding operation.
• The Tray/CDR Sensor could not detect the bottom
edge of CD or DVD during the CD/DVD feeding
operation.
Remove the jammed paper or the CD/DVD tray. p.21
Service required. Parts inside your printer
are at end of their service life. See your
manual for details.
Maintenance error This error is detected when the amount of the waste
liquid absorbed by the Waste Ink Pads has reached its
upper limit (when the protection counter has reached its
upper limit).
Replace the Waste Ink Pads and reset the
Protector Counter.
---
Bluetooth print adapter cannot be
recognized. Please remove and reinstall
the adapter.
BT communications error Had no response from the Bluetooth unit when the
printer started the Bluetooth communication.
Remove the Bluetooth unit and press the OK
button.
---
There is a problem with the IrDA
interface. See your manual.
IrDA communications error Had no response from the IrDA unit when the printer
started the infrared data communication.
Remove the IrDA unit. ---
The CD/DVD tray is not set correctly.
Reload the tray and press Start to
continue.
CDR error (correct set) Occurs when the printer starts to print on a CD or DVD
without the CD/DVD tray attached.
Automatically recovers from the error after a lapse
of three seconds.
---
CDR error (reset request) The CD/DVD tray could not be detected properly when
the printer starts to print on a CD or DVD.
Automatically recovers from the error after a lapse
of three seconds.
---
Table 1-3. LCD Error Messages and Possible Causes (continued)
LCD Messages Printer Condition Possible Causes Recovery from Errors Reference