Service manual

EPSON Stylus Photo R260/R265/R270, R360/R380/R390 Revision B
Disassembly/Assembly Disassembly of the Printer Mechanism 97
4.5.7 Ink System
 Parts/Components need to be removed in advance
All exterior parts/ All control boards / Middle Housing / Printer Mechanism
 Removal procedure
When installing the Stacker Assy, insert the tabs of the Left/
Right Stacker Guides into the hole of the Lower Housing, and
secure the guides with the screws. Tighten the screws in the order
given in Fig.4-111.
Figure 4-114. Reinstalling the Stacker Assy
Right Stacker Guide
Left Stacker Guide
Lower Housing
C A U T I O N
 Take extra care to avoid injury from sharp metal edges. Before
starting, see the page given below to check the dangerous edges.
• “4.1.8 Sharp Metal Edges (Danger!)” (p.62)
 Take extra care not to spill ink and contaminate the
surroundings. Also, when removing the Waste Ink Tube, be
careful not to spill the ink.
 Extra care must be taken to avoid injury from sharp edges of
the rib of the Main Frame.
 Be careful not to drop and damage the shaft of the Carriage
Lock and the Torsion Spring, as they easily come off.
Figure 4-115. Ink System
C H E C K
P O I N T
 See the section given below on how to unlock the carriage.
• “4.1.7 How to Unlock the Carriage (p.62)”
 Refer to the Orientation Definition below for the directions
indicated in the following procedures.
• “4.1.6 Orientation Definition (p.61)”
Shaft of the
Carriage Lock
Torsion Spring
Pump Section