Service manual

EPSON Stylus Photo R260/R265/R270, R360/R380/R390 Revision B
Disassembly/Assembly Disassembly of the Printer Mechanism 94
4.5.4 Waste Ink Pad
 Parts/Components need to be removed in advance
All exterior parts/ All control boards / Middle Housing / Printer Mechanism
 Removal procedure
1. Remove the three Waste Ink Pads from the tray.
Figure 4-104. Removing the Waste Ink Pad
4.5.5 P/S Assy
 Parts/Components need to be removed in advance
All exterior parts/ All control boards / Middle Housing / Printer Mechanism
 Removal procedure
1. Release the connector cables from the six tabs, peel off the acetate tape and
remove the Ferrite Core from the cutout of the Lower Housing.
Figure 4-106. Removing the Connector Cables of the P/S Assy
C A U T I O N
When removing the Waste Ink Pad, take extra care not to
contaminate the printer and surroundings with ink.
Insert the Waste Ink Pads into the trays inserting the slits of the
pads over the tabs on the trays. Make sure to push the pads as
far as they will go (until their top surface locate lower than the top
surface of the tray edges).
Figure 4-105. Reinstalling the Waste Ink Pads
Waste Ink Pad
Slit
Tab
C H E C K
P O I N T
Refer to the Orientation Definition below for the directions in the
following procedures.
•“4.1.6 Orientation Definition (p.61)”
Lower Housing
Ferrite core
Connector Cable
P/S Assy
Tab
Tab
Acetate Tape Position