Service manual
EPSON Stylus Photo R260/R265/R270, R360/R380/R390 Revision B
Disassembly/Assembly Disassembly of the Printer Mechanism 93
10. Remove three screws and remove the Printhead.
• Screw : C.B.P. M2.6x8 (tightening torque: 3-5 kgf.cm)
(The numbers shown in the figure indicate the order of tightening the screws.)
Figure 4-102. Removing the Printhead (1)
11. Remove the two Head FFCs from the connector on the back, and remove the
Printhead.
Figure 4-103. Removing the Printhead (2)
C A U T I O N
Take extra care not to spill ink and contaminate the surroundings.
Be extremely careful not to touch the nozzle surface, the ink supply
needles and the Head Cover, otherwise the nozzles may get clogged.
Figure 4-101. Handling of the Printhead
Nozzle surface
Printhead
Head Cover
Printhead
1
2
3
Tighten the screws in the order given in Fig.4-102.
A D J U S T M E N T
R E Q U I R E D
Whenever the Printhead is removed/replaced, the required
adjustments must be carried out.
•See “Table 5-4. Adjustment Items (p.116)” in Chapter 5
Head FFC
Connector
Printhead