Service manual

EPSON Stylus Photo R260/R265/R270, R360/R380/R390 Revision B
Disassembly/Assembly Removing Control Boards 86
4.3.6 Middle Housing
 Parts/Components need to be removed in advance
All exterior parts/components / Card Board (USB Board) / Main Board Unit
 Removal procedure
1. Remove the two screws.
• Screw : C.B.S. M3x10 (tightening torque: 5-7 kgf.cm)
(The numbers shown in the figure indicate the order of tightening the screws.)
Figure 4-79. Removing the Middle Housing (1)
2. Remove the Middle Housing taking extra care not to get the FFC caught on
the opening part.
Figure 4-80. Removing the Middle Housing (2)
3. Disengage the hook from the hole of the rib, and remove the Left Ground
Plate MB.
4. Remove the Right Ground Plate MB.
Figure 4-81. Removing the Middle Housing (3)
C H E C K
P O I N T
Refer to the Orientation Definition below for the directions
indicated in the following procedures.
•“4.1.6 Orientation Definition (p.61)”
Middle Housing
1
2
Front Frame
 Tighten the screws in the order given in Fig.4-79.

After installing the Middle Housing, check that the Left/Right
Ground Plates MB are properly grounded.
Removal Direction
Head FFC
Opening
Middle Housing
Disengage the
hook
Left Ground Plate MB
Removal Direction
Right Ground Plate MB