Service manual

EPSON Stylus Photo R260/R265/R270, R360/R380/R390 Revision B
Disassembly/Assembly Removing Control Boards 84
5. Remove the screw and remove the Panel Board.
• Screw : C.B.P. M3x10 (tightening torque: 5-7 kgf.cm)
• Positioning Hole: /Rib:
Figure 4-70. Removing the Panel Board (3)
6. Remove two screws and remove the LCD Panel and the Ground Plate LCD.
• Screw : C.B.P. M2x6 (tightening torque: 2-3 kgf.cm)
Figure 4-71. Removing the LCD Panel
7. Remove the SW Button (1) to (9) and the LED Light Guide Plate.
Figure 4-72. Removing the SW Buttons
8.
Peel off the double-sided tape and remove the two FFCs from the Shield Plate
PNL.
• Double-sided tape:
Figure 4-73. Removing the FFC

Removing the Panel Board (for R260/R265/R270)
1. Remove the four screws and disengage the hook ( ) and remove the Panel
Board Assy.
• Screw : C.B.P. M3x8 (tightening torque: 7-9 kgf.cm)
(The numbers shown in the figure indicate the order of tightening the screws.)
Figure 4-74. Removing the Shield Plate PNL (R260/R265/R270)
2. Disconnect the FFC from CN1 connector on the Panel Board.
3.
Remove two screws and remove the Panel Board from the Shield Plate PNL.
• Screw : C.B.S. M3x6 (tightening torque: 4-6 kgf.cm)
(The numbers shown in the figure indicate the order of tightening the screws.)
Figure 4-75. Removing the Panel Board (R260/R265/R270)
Panel Board
LCD Panel
Ground Plate LCD
1
2
3
4
5
6
7
9
LED Light Guide Plate
8
Shield Plate PNL
FFC (1)
FFC (2)
Panel Board Assy
1
2
4
3
CN1
FFC
1
2
Panel Board
Shield Plate PNL