Service manual

EPSON Stylus Photo R260/R265/R270, R360/R380/R390 Revision B

Disassembly/Assembly Removing Control Boards 82

4.3.4 Removing the Card Board (R360/R380/R390 only)

 Parts/Components need to be removed in advance

All exterior parts/components / Main Board Unit

 Card Board Removal

1. Remove the FFC Holder. (See FFC Holder removal on page 76)

2. Remove the five screws and remove the Card Board.

• Screw : C.B.S. M3x10 (tightening torque: 5-7 kgf.cm)

(The numbers shown in the figure indicate the order of tightening the screws.)

Figure 4-64. Removing the Card Board

 Card Board disassembly

1. Disconnect the FFC from CN1 connector on the Card Board.

2. Remove the screw and remove the Ground Plate CB.

• Screw : C.B.S. M3x6 (tightening torque: 5-7 kgf.cm)

Figure 4-65. Card Board Disassembly

C H E C K

P O I N T

R360/R380/R390 are equipped with a Card Board. Remove the

Card Board after removing the Main Board. Refer to R260/R265/

R270 & R360/R380/R390 Disassembly Flowchart(p.64).

Card Board

To match the FFC to the position of the Ferrite Core, twist and fold

the Head FFC as shown in the figure, then route it through the

Ferrite Core.

Figure 4-66. Routing the Head FFC (1)

 Screw the Card Board in the order given in Fig.4-64.

CN1

Ground Plate CB

Head FFC