Service manual

EPSON Stylus Photo R260/R265/R270, R360/R380/R390 Revision B
Disassembly/Assembly Removing Control Boards 78
4.3.2 Removing the Main Board Unit
 Parts/Components need to be removed in advance
All exterior parts/components / USB Board (R260/R265/R270 only)
 Removal procedure
1. Disconnect all FFCs and connector cables from the Main board.
2. Remove the all cables from the cable retainer on the Main Board.
Figure 4-51. Removing the Cables (R360/R380/R390 Main Board)
Figure 4-52. R360/R380/R390 Main Board
Figure 4-53. R260/R265/R270 Main Board
Table 4-5. List of Connectors and their Destinations
Main Board
Cable Retainer
CN16 CN15
CN9 CN8
CN12 CN10
CN11
CN4 CN3
CN14
CN7
CN6
CN13
CN1
CN5
C H E C K
P O I N T
For R260/R265/R270, when removing the connector cables, also
remove the GND Cable of the USB Connector Cable (CN2). This
GND Cable is screwed together with the Shield Plate in part .
CN No.
Color Destination Number of pins
R360/R380/
R390
R260/R265/
R270
CN1 --- FFC Card Board 15pin
--- CN2 White USB Board 5pin
CN3 CN5 FFC Panel Board 8pin
CN4 -- FFC Panel Board 11pin
CN5 CN16 FFC CR Encoder 6pin
CN6 CN8 FFC PF Encoder 6pin
CN7 CN7 Black APG Sensor 3pin
CN8 CN6 White PE Sensor 3pin
CN9 CN4 White CDR Guide Detection Assy 4pin
CN10 CN11 FFC Printhead
13pin
CN11 CN10
FFC Printhead
13pin
CN12 CN12 FFC Printhead 9pin
CN13 CN15 FFC CSIC 13pin
CN14 CN14 White CR Motor 2pin
CN15 CN13 Black PF Motor 2pin
CN16 CN3 White Power Supply 3pin
CN2
CN5
CN8
CN15
CN10
CN11
CN16
CN12
CN14CN13CN3
CN4
CN6
CN7
GND Cable
USB Connector
Cable (CN2)