Service manual

EPSON Stylus Photo R260/R265/R270, R360/R380/R390 Revision B

Disassembly/Assembly Removing Control Boards 77

3. From the rear side, push the positioning pin out with a screw driver or similar

tool, and slide the FFC Holder upward to remove it from the Middle Housing.

Figure 4-47. Removing the FFC Holder (1)

4. Straighten the fold of the Head FFC, and remove the FFC Holder pulling the

FFC out from the Ferrite Core.

Figure 4-48. Removing the FFC Holder (2)

When installing the FFC Holder, make sure to secure it with the

three hooked tabs and insert the positioning pin shown in Fig.4-47.

Figure 4-49. Reinstalling the FFC Holder

Removal Direction

FFC Holder

Push

Screw

driver

Positioning Pin

Straighten the Head FFC

and pull it out from the

Ferrite Core

FFC Holder

Ferrite core

: Hooked tab

FFC Holder

 When putting the Head FFC through the Ferrite Core, first

straighten the fold of the pair of two FFCs, then put the five

FFCs through the Ferrite Core one by one taking care not to

damage them. Then, route the FFCs after folding the pair of

two FFCs as they were (fold at shown in the figure).

Figure 4-50. Routing the Head FFC (2)

 Screw the USB Board in the order given in Fig.4-44.

 When screwing the USB Board, secure the GND Cable of the

USB Cable together with the screw as shown in Fig.4-44.

Head FFC (front)

Head FFC (back)