Service manual

EPSON Stylus Photo R260/R265/R270, R360/R380/R390 Revision B
Disassembly/Assembly Removing Exterior Parts/Components 75
 Install the Front Housing following the steps below
1. Install the Slot Cover. (R360/R380/R390 only)
2. With the two hooks on the inner bottom, insert the right
followed by the left.
3. Push the two parts and insert the hooks firmly.
Figure 4-40. Reinstalling the Front Housing (1)
4. Attach the Torsion Spring to the Slot Cover.
(R360/R380/R390 only)
5. While pressing the Front Housing with your thumb holding
the Middle Housing with your other fingers as shown below,
secure the screw (1) on the top left.
6. While pressing the Front Housing with your thumb holding
the Front Frame with your other fingers, secure the screw (2)
on the top right.
Figure 4-41. Reinstalling the Front Housing (2)
1
2
1
2
Front Housing
Middle Housing
Front Frame
[Right side]
[Left side]
7. While pressing the Front Housing with your thumb holding the
Middle Housing with your other fingers as shown below, secure
the screw (3) on the bottom left.
8. While pressing the Lower Housing with your thumb holding
the Front Housing with your other fingers as shown below,
secure the screw (4) on the bottom right.
Figure 4-42. Reinstalling the Front Housing (3)
 After installing the Front Housing, make sure that the Front
Housing is securely attached with no misalignment.
 When reinstalling the Torsion Spring, attach one end (1) of the
spring to the cutout of the Slot Cover, insert the coiled part
over the shaft of the Middle Housing, and attach the other end
(2) to the cutout of the Middle Housing. (R360/R380/R390 only)
Figure 4-43. Reinstalling the Torsion Spring
(R360/R380/R390 only)
 After reinstalling the Torsion Spring, check that the Slot Cover
opens and closes smoothly. (R360/R380/R390 only)
3
4
[Left side]
[Right side]
Front Housing
1
2
Cutout
Shaft
Cutout of Slot Cover