Service manual

EPSON Stylus Photo R260/R265/R270, R360/R380/R390 Revision B

Disassembly/Assembly Removing Exterior Parts/Components 74

3. With a flathead screwdriver or similar tool, disengage the two tabs on the

inner left and right sides.

4. From the bottom side of the Printer, insert a flathead screw driver into the hole

of the Lower Housing to disengage the two tabs. (With R260/R265/R270, the

tabs can be disengaged from the upper side of the Middle Housing.)

Figure 4-37. Removing the Front Housing (2)

5. Slide the Lower Housing toward you carefully avoiding the two bottom ribs,

and remove the Lower Housing.

 Removing the Slot Cover (R360/R380/R390 only)

1. Disengage the two tabs , and remove the Slot Cover.

Figure 4-39. Removing the Slot Cover

Removal Direction

Tab (right)

Tab (left)

[Bottom Side]

C A U T I O N

When removing the Front Housing, make sure to remove it in the

specified direction without tilting it, otherwise the tip of the bottom

ribs on both left and right sides may be scratched heavily or

broken.

Figure 4-38. Caution as to Removing the Front Housing

[Left inner side]

Front Housing

Removal Direction

Bottom Rib

Front Housing

Slot Cover

[Rear side]