Service manual

EPSON Stylus Photo R260/R265/R270, R360/R380/R390 Revision B
Disassembly/Assembly Removing Exterior Parts/Components 68
4.2.5 Upper Housing
 Parts/Components need to be removed in advance
Paper Support / Printer Cover / Front Cover / Right Housing / Left Housing / USB
Housing
 Removal procedure
1. Remove eight screws.
• Screw : C.B.P. M3x10 (tightening torque: 5-7 kgf.cm, silver)
• Screw : C.B.P. M3x10 (tightening torque: 5-7 kgf.cm, black)
• Screw : C.B.P. M3x10 (tightening torque: 5-7 kgf.cm, black, diagonally mounted)
(The numbers shown in the figure indicate the order of tightening the screws.)
Figure 4-21. Removing the Upper Housing (1)
2. Pull the left and right of the Upper Housing to disengage the two
positioning holes of the housing from the guide pins of the Lower Housing,
and remove the Upper Housing avoiding contact wit the ASF Unit.
Figure 4-22. Removing the Upper Housing (2)
1
2
8
5
7
6
3
Upper Housing
4
[Left side]
Positioning
Hole
Upper Housing
Removal Direction
Bushing
 Be careful not to let the cables get caught under the Upper
Housing at the position indicated with in Fig.4-22.
 Tighten the screws in the order given in Fig.4-21.
 (6), (7), (8) screws are black, and (6), (7) screws are mounted
diagonally toward the rear side of the printer. Keep that in
mind when removing/attaching the screws.